Upchurch Scientific Bottom-of-the-Bottle BOB Solvent Filter for 1/8 inch OD Tubing, 10 µm, PEEK, 10/0pk - A-440C

Bottom-of-the-Bottle™ Filter Assembly PEEK 10µm, for 1/8" OD - 100 per pack

Product Number: A-440C

Categories: Bottom-of-the-Bottle Filters, Filters, Filters & Frits, Fluidic Connections

This Upchurch Scientific, IDEX Health & Science, Biotech Fluidics All-PEEK, Bottom-of-the-Bottle Inlet Solvent Filter Assembly is the most recommended filtering unit designed. It's 100% PEEK construction delivers excellent chemical resistance and is specifically designed to be inert to most solvents. Our Filter features a bottom frit that will draw solvents to within .080" of the bottom of your solvent bottle. It has a porosity of 10µm and is for 1/8"OD tubing. This easy to operate filter requires no fittings.

Related Products:

• A-435 - Bottom-of-the-Bottle™ Filter Assembly PEEK 2µm, for 1/8" OD

Available in the Following Configurations:

• A-440 - Single pack
• A-440C - 100 per pack

Bottom-of-the- Bottle™ Filters

These uniquely designed Bottom-of-the-Bottle™ Filters effectively protect your system by filtering out particulate matter that my otherwise damage expensive hardware.

All-PEEK Bottom-of-the-Bottle Solvent Filters

• Most recommended filtering unit
• 100% PEEK polymer construction
• Easy operation — no fittings required

These biocompatible filters are made from 100% PEEK polymer, including the two built-in PEEK frits. The bottom frit (2 μm or 10 μm) will draw solvents from within 0.080” (2.0 mm) of the bottom of the solvent bottle. The 2 μm frit on the side may
be used for a 1/8” OD helium sparging line.

To use, simply press fit your appropriately sized fluoropolymer tubing firmly into the top holes. That’s it!