QLA Small Volume Spin ON/OFF Mini Basket Shaft, Agilent/Vankel/Distek/Hanson compatible, 316 Stainless Steel, Serialised - MINBSHAFT

Small Volume Spin ON/OFF Mini Basket Shaft

QLA Part Number: MINBSHAFT

Small Volume Spin ON/OFF Basket Shaft, 316 SS, Serialized (Use with Upper Shaft LCB15-HR, NDT10-HR, NDT12-HR)

Fits Bath Models:

• Agilent: 705, 708-DS, VK700/710, VK7000/7010
• Distek: 2100 A/B/C, 2500
• Teledyne Hanson: SR8/ SR8-Plus

Cert of Compliance: Yes
Material: 316 SS
Serialized: Yes
UOM/Pack Size: EACH

Related Products:

• PADHLD-12A  - 12 Position Full Length Paddle/Basket Shaft Holder
• PADHLD-16A - 16 Position Full Length Paddle/Basket Shaft Holder
• PADHLD-UNBSK - 16 Position Full Length Paddle/Basket Shaft Holder with Basket Holder Tubes
• LCB15-HR - 15" (380mm) Spin ON/OFF Upper Shaft for Small Volume and Hanson Vision Classic 6
• NDT10-HR - 10" (254mm) Spin ON/OFF Upper Shaft for Small Volume and Hanson SR8-Plus
• NDT12-HR - 12" (305mm) Spin ON/OFF Upper Shaft for Small Volume and Hanson Vision Elite 8
• MINBSK-10 - Small Volume 10 Mesh Mini Basket, 316 SS, Serialized
• MINBSK-20 - Small Volume 20 Mesh Mini Basket, 316 SS, Serialized
• MINBSK-40 - 40 Mesh Small Volume Mini Basket

QLA Basket Shafts are manufactured from electropolished 316 Stainless Steel. Clip style and O-ring style shafts are available for most Dissolution Instruments. Clip style shafts utilize a proprietary, spring tempered clip, which retains the original gripping tension far longer than conventional shafts. Clip style shafts comply with USP (711) and Original Equipment Manufacturers dimensional specifications. O-ring style shafts comply with Original Equipment Manufacturers dimensional specifications and are guaranteed to properly interface with the designated dissolution basket and spindle. Both clip style and O-ring style shafts are precisely manufactured to limit rotational wobble to levels far below USP (711) specifications.     

All basket shafts are serialized and supplied with a Certificate of Conformance (COC) stating that they are USP compliant, where applicable, and that they meet the machine manufacturer specifications. A Certificate of Analysis (COA) stating actual dimensions is available at an additional cost.